About Innosilicon T3 43T

Innosilicon Terminator 3 (T3) — 43T mining device is a bitcoin mining ASIC hardware with the highest hash rate. The Innosilicon T3 43t, also known as Terminator3-43T is manufactured by Innosilicon and was released in January 2019.

Algorithm of the Innosilicon T3 43T

It works with the Secure Hash Algorithm (SHA-256) algorithm, and it can mine coins like Bitcoin (BTC), Bitcoin Cash (BCH), Terracoin (TRC), to mention but a few. But the most profitable coins to mine with this model are Bitcoin, NiceHash, Bitcoin SV, etc. It has two cooling fans of 12cm 12038 and 12V 2.7A, which helps in heat emission. There are two power interfaces on the control board.

The four-pin interface provides the controller. Power supply, 6pin interface works for the two cooling fans. The main engine and PSU are integrated. The power supply has a switch that makes the maintenance and use of the device easier. The power plug and the control panel cable plug are not in the same location, which may impact the upper and lower shelves.

The official recommendation is to buy a 3 * 2.0mm power cord gotten from Innosilicon.

The appearance of Innosilicon T3 43T

The outer casing is die-casted with aluminum. The weight is about 10kg, and the size dimensions are 430mm x 141mm x 220mm, which makes it compact and smaller in size than the T2T model. Innosilicon T3-43T bitcoin miner has a very high hash rate with an official value of 43Th/s and power usage of 2100W. Impressive right?

But that's not all; Innosilicon built the Terminator 3 with an innovative design to generate a powerful SHA256 43TH/s (± 5%) hash rate with only 2100W (10%). The 48.83W/TH performance guarantees that you have the much-needed advantage in mining in the foreseeable future. Innosilicon T3 is designed to be a long-lasting product, with many improvements that giving it an edge over its predecessors concerning longevity.

Its latest dynamic, frequency scaling technology, and an extra cooling system guarantee efficiency and reliability. And lighter than T2T-32T, the noise is additionally better controlled.

Noise Level of Innosilicon T3 34T

The background level within the close-range test is 79–88 decibels, 74 decibels measured in two meters, so the noise is better than the T2T-32T control. The noise is high, and this can not be set up in a residential environment for the new miners.

Temperature of Innosilicon T3 43T

When the air temperature is 28 degrees, the mining machine's temperature is 45.6 degrees, and the peak value is 48 degrees. The device temperature outlet is about 35 degrees, so the device supply's temperature and the connection plate of the mining machine is about 32 degrees.

Hash Rate and Power Consumption of Innosilicon T3 43T

In the factory default mode, the calculated power is 42.98T/s, approximately 43T, the power consumption of the whole machine is 2100W, the total energy consumption ratio is 49.81W/T, the receiving rate of the mining pool is maintained at 99.9%, and the fan rotation number is around 95%-100.

Profitability of Innosilicon T3 43T

With a block time of 9m 30s, a block reward of 7.88167, plus difficulty of 16787800M, the Innosilicon T3 43t is a very profitable ASIC miner. But due to the cost of electricity, and maintenance the profitability is reduced. The profitability changes based on the market value of the coin that is being mined. For new miners looking to go into mining with this device, the profitability can also be affected by several factors besides the price of the coin in the market.